The ControlByWeb X-DTHS-P is a new temperature and humidity sensor probe and used in conjunction with many of the 400-Series, X-600M, and WebRelay-Wireless products. Temperature and humidity are accurately measured, digitized, and sent to the ControlByWeb module over a serial 1-Wire Bus.
One or multiple sensors can be attached to the 1-Wire Bus and its cables can be extended up to 600 feet (approximately 182 Meters) from the module without any loss of measurement accuracy.
The X-DTHS-P comes with two mounting options:
|  |
The sensor is able to be installed outdoors but must be protected from the elements. Insure that you install the sensor in a protected location away from rain or direct sunlight.
No additional software, or power supply required. Simply connect and set up on any of our compatible products.
Temperature Sensor Wiring & Mounting
The sensor has three wires which are connected to a compatible ControlByWeb device on the 1wire Bus. The cable can be extended with additional wire if needed (182M max).
